I am using this as a stand a lone remote starting unit. I have progrmmed my evo all qith t harness chrt5 with the flah link updater. When all connections are made, and key is programmed, I push the lock button on my OEM Remote 3x and the led on evo all cycle through the blue yellow red and the truck locks and unlocks. However, when it tries to start, the blue led light turns off and makes a clicking noise. Does the black/yellow wire need grounded at all times? In another Question someone states no, so i did not ground that wire. Should I ground that wire and try again? Also, does the instructions per set F states to cut the yellow/red wire connected to the red 6 pin connector. Is that also necessary?